Summary
Bureau Veritas is seeking a Process Engineer in Abu Dhabi for oil and gas projects, including upstream and pipeline work. The role covers process design review and verification across conceptual, FEED, and detailed engineering stages, along with preparation and review of engineering documents and calculations. Candidates should have 8 to 12+ years of process design experience, a BTech or MTech in Chemical Engineering, and at least 75% marks in engineering. Experience with tools such as HYSYS, PROMAX, and HTRI, and fluent spoken and written English are required.
The posting
As published on bureauveritas.com. Pulled from the employer's site and shown as they wrote it.
Process Engineer /Process Design Engineer
Process design and engineering experience of 8 to 12+ years in Oil & Gas projects upstream projects, pipeline projects covering design, conceptual engineering, FEED, Detailed engineering.
Required Experience:
The candidate should have experience in preparing the following deliverables for Basic Engineering, FEED, or EPC projects with a reputed international EPC consultant.
- Design Basis
- Licensor Technology Evaluation
- PFD and P&ID Preparation and or review for Urea Plant
- HMB
- Process data sheets, Equipment list, Line list, Load list, Tie-In list, Fluid list,
- PSV Relief load estimation, PSV sizig
- Flare sizing, KOD sizing
- Pump sizing
- Compressor Calculations, Anti surge design, settle out calculations etc
- Steam generation and sizing calculations
- Design of Separators, columns, Heat Exchangers, tanks
- Hydraulic calculations, PSV sizing, Control valve sizing calculations
- Interfacing with Piping, Mechanical Instrument engineers, Commissioning Engineers as required during the EPC stages
- 3D Model Review
- vendor offer reviews
- Experience across conceptual design, FEED, and detailed engineering phases.
- Operation experience is not preferred.
Software/Technical Skills & Tools
- Experience with process simulation and engineering software such as HYSYS, PROMAX, Flare network analysis tools, and HTRI.
- Strong understanding of process design, sizing, and optimization techniques.
- Ability to critically review calculations and propose practical engineering solutions.
- Strong technical documentation and report-writing skills.
- Fluent in spoken and written English.
Education:
- B tech Chemical Engineering / MTech Chemical Engineering
- 75% Marks in engineering are mandatory
Job Profile
Key Responsibilities
- Perform process design review and verification across conceptual, FEED, and detailed engineering stages.
- Prepare and review process design basis, philosophies, and engineering calculations.
- Review and verify Process Flow Diagrams (PFDs), Piping & Instrumentation Diagrams (P&IDs), and Heat & Material Balances (HMB).
- Review process datasheets, equipment lists, line lists, tie-in lists, fluid and load lists.
- Perform and review PSV relief load estimation and PSV sizing calculations.
- Review flare system calculations, knockout drum sizing, and associated hydraulics.
- Review pump, compressor, and rotating equipment process calculations including anti-surge and settle-out analyses.
- Review design of separators, columns, heat exchangers, tanks, and other process equipment.
- Perform hydraulic calculations and control valve sizing reviews.
- Interface with piping, mechanical, electrical, and instrumentation disciplines during EPC execution.
- Participate in 3D model reviews and vendor technical document reviews.
- Prepare and review technical reports, calculation notes, and design review comments.
- Ensure compliance with applicable international codes, standards, and project procedures.
- Site Visit : The candidate may be required to occasionally visit project sites to conduct audits or verification activities.
Location: Abu Dhabi, UAE